A large series of electrically conductive tapes for EMI/RFI shielding, ideal for grounding, conductance and EMI/RFI shielding of housings/Faraday cages.
Many EMI problems can be solved easily with Mu-copper foil or tape. Mu-copper tape is available with or without (conductive) self-adhesive and an optional insulation layer. Mu-copper tape can be cut to any width starting at 3mm and can be delivered from stock. The most commonly used width is 25mm; standard roll length is 16.5 meters.
When large surfaces are to be shielded, it is recommended to cover most of the surface with Mu-copper foil, possibly in combination with tape with a conductive self-adhesive. This solution is much cheaper than covering the entire surface with tape strips.
Mu-copper tape can also be delivered as die-cut, according to your drawing, on strips or in pieces (as stickers), with optional self-adhesive. Almost every shape and size is possible.
Many factors influence the actual effectiveness of an EMI/RFI shielding tape after it has been applied, such as the type and thickness of foil, type of adhesive, closeness of contact, smoothness of application surface, strength, and frequency of the EMI/RFI signal, etc. Still, attenuation values can be determined using standard tests and fixtures.
For EMI/RFI shielding tape, typical shielding effectiveness (far field) is in the range of 60dB to 80dB (10 kHz to 20 GHz).
🟥Mu-copper foil (0.12 mm thickness)
Please note: These values are measured under laboratory conditions. In other situations, results may differ. Please read our Guarantee.
A flexible metal foil with a highly conductive self-adhesive on one side, with a release liner
Copper tape 3201 is available in standard and custom widths and lengths. The standard length is 16.5 meters.
Similar to Tape 3201, but with a layer of tin added for protection against corrosion and better solderability.
A flexible metal foil, laminated on 2 sides with a conductive self-adhesive; available in sheets and rolls.
Similar to Tape 3201, but with a paper layer added to insulate the top layer of copper.
(with conductive adhesive)
|3201 (0.035 mm thick),|
3212 (0.12 mm thick),
3218 (0.18 mm thick)
(with standard adhesive)
|Foil material||soft copper||soft copper||soft copper||soft copper with paper|
|Foil thickness||0.035 mm||0.035 mm||0.035 mm||0.035 mm|
|Total thickness||0.060 mm||0.060 mm||0.085 mm||0.060 mm|
|Adhesive||synthetic conductive resin||synthetic conductive resin||synthetic conductive resin||synthetic conductive resin|
|Adhesive performance||4.5 N/cm||4.5 N/cm||4.5 N/cm||4.5 N/cm|
|Tensile strength||55 N/cm||40 N/cm||55 N/cm||55 N/cm|
|Temperature resistance||155 °C||155 °C||155 °C||–|
|El. resistance through adhesive||0.003 Ohms||0.003 Ohms||0.003 Ohms||0.003 Ohms|
|Standard roll widths (mm)*||10, 25, 50, 100|
Other width on request
|Roll lengths*||Min. 16.5m (standard)|
Other roll length on request
|These values are measured under laboratory conditions.|
Results may differ in other situations. Please read our Guarantee.
*Other roll widths/lengths on request
Get a quotation
Fill in the form below