Skip to content
We have decades of experience in constructing the following shielded rooms and components:
We offer Mu-copper Faraday cages, prefab Faraday cages, anechoic chambers, etc.
Faraday cage general selection graph
Please note : These values are measured under laboratory conditions. In other situations, results may differ. Please read our Guarantee.
To determine which type of shielded room you need, below you will find a graph showing the respective shielding performances of a high-performance prefabricated cage, a Mu-copper cage, a magnetically shielded room and two tents (one with a single layer and one with a double layer). The graph shows the attenuation for each type of Faraday cage at different frequencies. What is important when choosing your Faraday cage is the required attenuation (emission reduction) and of course the frequency ranges for which attenuation is desired. Higher attenuation equals higher emission reduction.
Apart from the fact that the Faraday cage and its door should operate in the same frequency range in order to yield the desired reduction, other components like power-line filters, honeycomb ventilation panels and screened windows should also operate in the same frequency range.
We can make sure your situation will comply with any national or international EMC regulations. If you would like to receive our brochure and sample package, including a sample of the “Mu-copper wallpaper system”, please contact us.
We produce Faraday cages, shielded chambers and all other components needed to construct shielded rooms, such as:
In addition we produce TEMPEST equipment for encrypted communications, and even welded EMP bunkers. We also design new shielding products according to the client’s wishes with very short delivery times.
We assist our clients from the design phase through the construction phase, so our engineers are ready to advise you at any step in the process to achieve the optimal solution.