Skip to content
Combined EMI-shielding and water-seal gasket for grooves and door/lid constructions
The 8000 series Endless gaskets are ready-made gaskets produced in accordance to customer specification. They are suitable for many applications where both an EMI-shielding gasket and a water seal are required.
The 8000 series Endless gasket consists of a rectangular EMI gasket like Amucor shield 6800 series, Standard shield 7000 series or Ultra soft shield 7400 series, combined with a closed-cell water seal.
All gaskets can be made with a self-adhesive strip for easy mounting. Gasket materials for the 8000 series Endless gaskets are watertight at 30% compression, depending on the construction.
The gasket can be supplied with the water sealing/IP seal on the outside of the gasket (IP seal position O), or with the water seal at the inner side of the gasket (IP seal position I).
Disk or washer-type compression stops can be included to prevent over-compression.
Used at bolt holes
Used next to bolt holes
Examples of different uses for the Endless gasket (The solid Gray part is the water seal)
1. Endless gasket used in a flat lid on a curved housing construction
2. Endless gasket used in a curved lid on a curved housing construction
3. Endless gasket used in a groove
Please Note: If you send us a drawing, please include the dimensions shown above.
A : Width (mm)
B : Height (mm)
R : Corner radius (mm)
Z : Width of the waterseal (mm)
X : Width of the EMI gasket (mm)
Y : Height of the EMI gasket (mm)
Get a Quotation
Fill in the form below