Skip to content
Our Conductive silver plated copper coating comes as ready-to-use product. It is designed to provide low resistance in thin film thickness, and exhibits superb EMI shielding and grounding properties. This product has excellent adhesion to most plastics and is specially suitable for electronic equipment housing. It exhibits superb long term shielding and grounding properties while providing an esthetically pleasant appearance.
The resin will dry to touch in approx. 5 – 10 minutes after application and it will achieves maximum conductivity within 4 to 16 hours when air dried. It is designed to prevent electrical interference that penetrates enclosures made from thermoplastics and other insulating materials. The coating also prevents static build up.
It is recommended that an grounding connection is made to achieve maximum shielding performance. A suitable material for this is Part number 3201, Copper shielding tape which can simply be stuck onto the coated surface or over-sprayed with the electrically-conductive copper coating. The coating, once it has been applied, has a copper colored finish.
For easy application of the electrically-conductive nickel coating, we have a small sprayer which is to be connected to a compressor.
|Surface resistance at 25 micron (thou) ASTM D257||0.5 ohm/square or less|
|Conductive additive||Silver plated copper|
|Viscosity||16 – 18 sec. (zahn cup 2)|
|Specific Gravity||1050 kg/m3|
|Typical coverage||5 m2/kg at 25 microns (dependent on substrate)|
|Drying time: touch||5 minutes|
|Drying time: full||4 up to 16 hours (air dry)|
|Shelf life||12 months|
|Sheet resistance||<0.50 /square at 25 m|
|Attenuation||75 dB at 50 µm|
|Maximum service temperature||95°C|
Get a Quotation
Fill in the form below