High temperature conductive coating

An elemental static silicone/acrylic coating which offers great electro static resistance in addition to its anti-corrosion properties. Continuous heat resistance is provided up to 350 °C.

Typical applications would include oven interiors, flow solder machines etc.

The 3840 high temperature conductive coating is available in cans of 5 Liter and cans of 20 Liter


Phenylmethyl polysiloxane resin, acrylic resin, conductive mineral additive, titanium dioxide.

3840 High temperature conductive coating

Technical specifications

Surface resistivity108Ω/sq. (ASTM D257)
ColourLight grey
Specific gravity1.3g/cc
Coverageapprox. 4 – 6 sq mtr/ltr.
Drying time (air)1 hour – touch dry
Stoving at 220 °C10 – 15 minutes
Shelf life6 months


Surface preparationAll contaminants including mould release, grease and dirt must be removed. A suitable primer may be necessary on certain substrates.
MixingSome settling may occur in the can, so care must be taken to mix in all solids. Should any dilution be necessary, thinners should be used.
ApplicationThe 3840 High temperature conductive coating can be used by a conventional spray gun ( 40 – 50 psi pressure), or by brush coating.
StovingAllow parts to air dry for a minimum of 24 hours then oven cure at a temperature of 100 °C for approx. 10 minutes.


This product is Highly flammable. Keep away from heat, sparks and open flames. Keep all containers closed when not in use. Use under well ventilated conditions. Personal respiratory protection should be worn under spraying conditions. Such devices must be used in accordance with the manufacturers instructions. Avoid contact with skin. Wear protective gloves and clothing. Wash thoroughly with soap and water after use. If accidentally swallowed, seek medical advice.


For this product there are no free samples available